Nomore production: extract, reaction and injector

Prepare supplies and equipment

Buy the Retired Chemist introduction through Joe Wild, or use the Chemist start. The supplier sells common chemical packs and may bring restricted packs. Unpack packs you own. Prepare a Composition Spectrometer, measuring tools, clean liquid containers, a receiving container fitted with a filter, a Heating Plate with at least two chemical modules, a powered Evaporator and a Chem Finisher. Two modules unlock temperature controls; zero fixes the heater at 99°C and one at 160°C. Check the container’s actual temperature.

Make the product

1. Buy Dream Caps from the Shady Farmer or grow them in hydroponics. Blend into a clean liquid container, scan the mush volume, and add alcohol. An initial five times the mush volume in actual alcohol reaches the extraction ratio’s cap; weaker mixtures still extract less efficiently. Bottled alcohol from common supplies is only 70%.

2. Keep actual temperature 40–50°C, preferably around 45°C, until mush is gone. Extract before filtering. Treat protein with acid or base, neutralize leftovers, and filter debris. Treat any fat before adding the Lipobond Agent for production.

3. Evaporate the extraction alcohol before mixing the reaction. Rescan the remaining Dream Cap Extract. For 10mL actual extract, add 10mL actual Reducing Agent and about 2.5mL actual Lipobond Agent. Lipobond is a catalyst here and remains after reaction.

4. Keep actual temperature 45–55°C inclusive; 50–55°C is faster. Extract and Reducing Agent decrease equally, producing Nomore and Insoluble Debris. If both remain unchanged, check temperature, Lipobond and alcohol before adding more reagent.

5. Alcohol must stay at or below 10% of the current mixture throughout. Reaction shrinks the mixture, so a batch starting at 10% can stop after its first step. Removing alcohol first avoids this. If Reducing Agent remains at the end, add an equal actual volume of cleaned Dream Cap Extract and react again.

6. Filter the new debris, then evaporate Lipobond Agent and any remaining water/alcohol. Move the main container to the finisher and select Nomore Injector. Each injector uses 4mL total dry mixture. Oxymore Injector is a different product.

Check the result

10mL extract plus 10mL Reducing Agent gives about 6mL Nomore and 4mL debris, before removing Lipobond. The starting 20mL does not become 20mL active product.

For both recipes, water + alcohol + Lipobond must total no more than 0.1mL before finishing. Scan one output before processing the rest. Four chemical modules stop the finisher adding its own impurities; they do not clean dirty input.

Alcohol and reagent supply · Other products and leftover reagents · Phanta production: precursor, temperature and finishing